Two polyurethane coatings for surface. And adjust the surface to be smooth. Durable It can be protected from chemical oil, UV light, and good scratch resistance, with a seamless shine, easy to use with a trowel. Paint brush or roller Suitable for industrial factories, warehouses or areas where durability.
SCOPE OF USE
- Adjust the surface to smooth. Or use a coating Can be used both surface plaster concrete and steel both outside and inside.
RAW MATERIAL
- Polyurethane 2 elements (Part A: Polymer and Part B: Hardener)
- Chemical additives such as antifungal substances. Humectants Hardener, etc.
- Pigment
HOW TO USE
- Surface preparation
- Scrub the surface to be painted smooth, no dust, oil, chemicals or anything that may affect adhesion. And no skin is unhealthy.
- In case of surface cracking, repair as follows.
- If there is a small cracks with a width of not more than 1 centimeter should be repaired with Polyurethane Injection.
- If a large cracks with a width of more than 1 centimeter should be extended to widen the groove. Then repair with Mortar Rapid Hardening Mortar (M601). - Then clean the floor. Then super Skim Coat Hardening (M651) is applied to enhance the surface strength.
- Wait until the M651 is completely dry and smooth the surface.
- The surface to be applied must be completely dry. Surface moisture content must not be more than 4% RH.
- Primed with NP301P Primer Use a brush or roller to make a one off, then let it dry completely.
Warning
- Part A: Part B homogeneous mixing process is very important. If mixed well, the resulting film will not stick to the surface.
- The surface to be painted must be completely dry. Because the moisture will swell, swell, and slip easily.
- While mixing and using Be careful not to drip sweat or thinner into the paint to paint.
- Cause swelling.
- Part A and Part B should be used within 30 minutes.
- Thinner can be used to wash equipment and paint container.
QUALITY OF USING
Packaging dimensions/ Packing weight (Part A/ Part B)/ Compound rate (Part A: Part B)/ Estimated painting area
¼ gallon/ 0.9 kg/ 0.45 kg/ 2: 1/ 5 square meters
1 gallon/ 3.8 kg/ 1.9 kg/ 2: 1/ 20 square meters
Note : * For one trip.
FEATURES OF NP302
Touch Dry/ Hard Dry/ Pot life (25ºc)/ Fully Cure/ Mohs Hardness/ Hardness (Shore D)
20-30 min./ 2 h/ 30 min./ 7 days/ 4/ Min. 70