Banner_Board
You are here:Home/Fiber Cement/Fiber Cement Board/TPI Jointing Compound (M660)

TPI Jointing Compound (M660)

Special-purpose mortar used with fiber cement to plaster both fiber board type of flat and groove due to it's very easy to work slip. Causing work smooth and retain for screws fixing the fiber cement. Flexibility and high adhesion, no cracks, no cracks, no sanding to sand easily.

>>Shop Now<<

SCOPE OF USE

Used for plastering, sealing and grooving. Keep the head of the fiber cement screws. And some plaster is Skim Coat.

RAW MATERIAL

  • TPI Portland Type 1 Cement according to ASTM C-150 and TIS 15-2555
  • Fine Crushed Limestone through the process of drying and size.
  • Additives Extra high adhesion strength.

HOW TO PREPARE THE SKIN AND USE.

- In the case of plastered joints with a grooved sheet of fiber cement.

  1. Clean the area where the cementitious cementitious bonding is to be applied. By eliminating dust and what can affect adhesion.
  2. Mix cement plasterboard, seal fiber cement joints with clean water. Using a ratio of 1 kg of water per 300 ml of water, mix well. Do not leave the lumps that are not into the water.
  3. Apply to the joints of fiber cement sheets using a trowel. The plaster is smooth and full.
  4. Allow the mortar to dry and harden for about 2 hours, then use sandpaper to smooth the surface.

- In case of plastering joint of groove and mortice

  1. Clean the area where the cementitious cementitious bonding is to be applied. By eliminating dust and what can affect adhesion.
  2. Mix cement plasterboard, seal fiber cement joints with clean water. Using a ratio of 1 kg of water per 300 ml of water, mix well. Do not leave the lumps that are not into the water.
  3. In the case of Fiber Mesh, the mixed mortar is used to seal the fiber cement sheet. Use a trowel plaster to smooth and full seam before then close Fiber Mesh by pressing smooth. Close to the mortar to keep track of it. Leave it for about 1 hour.
  4. Plastered with lime cement joints, fiber cement Plastered smoothly with grooved grooves of fiber cement.
  5. Allow the mortar to dry and harden for about 2 hours. To smooth the surface.

- Screw head screws of fiber cement.

  1. Always keep the screw heads always in the same plane as the surface of the fiber cement board.
  2. Clean the area where the cementitious cementitious bonding is to be applied. By eliminating dust and what can affect adhesion.
  3. Mix mortar, fiber cement with clean water. Using a ratio of 1 kg of water per 300 ml of water, mix well. Do not leave the lumps that are not into the water.
  4. Put on the groove of the screw head to full. Using a rubber trowel or trowel.
  5. Allow the mortar to dry and harden for about 2 hours, then use sandpaper to smooth the surface.

    In This Category Other Categories: «Well, TPI's board."

RFQ

Form by ChronoForms - ChronoEngine.com

More in this category: « TPI DECO BOARD