Ready-made mortar for some plastering Work with a trowel polishing, it is applied as Finishing Coat, making the skin smooth. Covering plaster walls with sand, crack, sesame and uneven surface. Can be made of bare walls. Or repaint
SCOPE OF USE
Can be applied on concrete walls. Or plaster walls, such as the wall plastered with M100, M100C, M200 or M210, etc. can also be used wall posts. To cover cracks or crevices.
RAW MATERAIL
- TPI Portland Type 1 Cement according to ASTM C-150 and TIS 15-2547
- Chemical additives such as additive properties of water. Additives, adhesives, etc.
- Fine limestone crushed
HOW TO USE
1. Wall preparation
- In cases where the walls are smooth, Super Skim Coat TPI can be plastered without the need for plastering.
- If the wall is plastered with very rough surface, such as concrete wall, use M100C pre-plastering. Try to smooth the surface evenly. And wait for the plaster to dry completely. So it is plastered with Super Skim Coat TPI.
2. Using
- Mix Super Skim Coat TPI plaster with water using 1 liter bag (20 kg) per 8 liters of water. Without resting the plaster to the water.
- Super Skim Coat TPI plaster with polished steel By thin-walled plastered up the floor one after the plaster. Apply in the same way until the desired thickness (about 1-2 mm).
- Before painting, fine sandpaper can be used to smooth the surface.
Thickness of plaster/ The plastered area is 20 kg./ The amount of cement per 1 sq.m.: 1-2 MM./ 10SQ.M./ 2 KG.